Asus P5N73-CM - Manual (Page 33)

ASUS P5N73-CM 1-23
3.. Serial.ATA.connectors.(7-pin.SATA1-4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
Connect the right-angle side of SATA signal cable to
SATA device. You may also connect the right-angle
side of SATA cable to the onboard SATA port to avoid
mechanical conflict with huge graphics cards.
4.. Chassis.intrusion.connector.(4-1.pin.CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P5N73-CM SATA Connectors
R GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SA
TA
2
SA
TA
3
SA
TA
1
SA
TA
4
P5N73-CM
CHASSIS
+5VSB_MB
Chassis Signal
GND (Default)
P5N73-CM Intrusion Connector
R
P5N73-CM