Asus RX3042H - Manual (Page 48)

Router Setup RX3042H User's Manual
36
Figure 5.5. WAN – Dynamic IP (DHCP client) Configuration
5.2.4.1 Configuring Dynamic IP for WAN
Follow the instructions below to configure dynamic IP settings:
1. Open the
Network Setup configuration page by clicking the
Router Setup -> Connection menu.
2. Select which WAN port (WAN1/WAN2) to configure for
dynamic connection mode.
3. Select Dynamic from the Connection Mode drop-down list as
shown in Figure 5.5. Note that the IP addresses for the primary
and/or the secondary DNS servers are automatically assigned
secondary DNS servers if you want to use your preferred DNS
servers; otherwise, skip this step.
9. (Optional) Change the MTU value if necessary. If you do
not know what value to enter, leave it as is. For dynamic IP
connection mode, the range of MTU is from 546 to 1492. The
default value is 1492.
10.Enter appropriate connection settings for Disconnect after Idle
(min) and Connect on Demand.
11.Click Apply to save the settings.
5.2.4 Dynamic IP
Dynamic IP is most often used by the cable modem service
providers.