Asus P2B-D2 - Manual (Page 85)

ASUS P2B-D2 User’s Manual 85
WINDOWS NT 4.0
D. Install Adaptec AIC-7890 Driver
If you are performing a first time Windows NT installation, see the "Installing Win-
dows NT v4.0 with the FMS Driver" sections below.
If Windows NT is already installed on your system, see the "Updating the FMS
Driver under Windows NT v4.0" sections below.
Installing Windows NT v4.0 with the FMS Driver
The following instructions explain how to install the Adaptec 7800 Family Manager
Set v3.01, while installing Windows NT v4.0.
1. Start your system with the Windows NT Boot Diskette in the floppy drive.
2. Insert diskette #2 when prompted. After a few moments you will see a blue
screen. To setup Windows NT now, press ENTER.
3. Press S to skip Windows NT Setup's auto detection of your SCSI adapter.
4. Press S again to specify an additional device.
5. Press ENTER to select Others, and insert the Adaptec 7800 Family Manager Set
v3.01 diskette.
6a. For non-Ultra2 host adapters, Select the "Adaptec AHA290x/291x/294x/394x/
4944/AIC78xx PCI SCSI Controller(NT 4.0)" and press ENTER or
6b. For Ultra2 host adapters, Select the "Adaptec AHA-294xU2/AIC-7890/91 PCI
Ultra2 SCSI Controller(NT 4.0)" and press ENTER.
7. If you want to add other host adapters (that are not a part of the 7800 Family), do
so at this time by pressing 'S' and repeating step 5 for each additional adapter
and inserting the appropriate disk provided by the hardware manufacturer. The
Adaptec 7800 Family host adapters use the same driver; it is not necessary to
install the AIC78XX.SYS or AIC78U2.SYS driver again.
8. Press ENTER to continue with the Windows NT operating system setup. Follow
the instructions given on screen and in the Windows NT installation documenta-
tion.
WINDOWS NT 4.0 D.
AIC-7890 Driver