Asus P2B-D2 - Manual (Page 29)

ASUS P2B-D2 User’s Manual 29
III. INSTALLATION
9. Primary / Secondary IDE Connectors (Two 40-1 pin IDE)
These connectors support the provided IDE hard disk ribbon cable. After con-
necting the single end to the board, connect the two plugs at the other end to
your hard disk(s). If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumper accordingly. Please refer to the docu-
mentation of your hard disk for the jumper settings. BIOS now supports SCSI
device or IDE CD-ROM bootup (see “HDD Sequence SCSI/IDE First” & “Boot
Sequence” in the BIOS Features Setup of the BIOS SOFTWARE) (Pin 20 is
removed to prevent inserting in the wrong orientation when using ribbon
cables with pin 20 plugged).
TIP: You may configure two hard disks to be both Masters using one ribbon
cable on the primary IDE connector and another ribbon cable on the secondary
IDE connector. You may install one operating system on an IDE drive and an-
other on a SCSI drive and select the boot disk through BIOS Features Setup.
P2B-D2 IDE Connectors
NOTE: Orient the red stripe on the
IDE ribbon cable to Pin 1
PIN 1
Primary IDE Connector
Secondary IDE Connector
10. Chassis Intrusion Sensor Lead (4-1 pin CHASSIS)
This lead is for a chassis intrusion monitor or sensor. The sensor is triggered
when a high level signal is sent to the “chassis signal” lead. This occurs when a
panel switch or light detector is triggered. This function requires optional trigger
switches to be installed.
P2B-D2 Chassis Open Alarm Lead
+5VSB Chassis Signal Ground
Connectors
III. INST
ALLA
TION