Asus P2B-D2 - Manual (Page 101)

ASUS P2B-D2 User’s Manual 101
/******************************************************************/
/* END OF LCU INFORMATION TO BE ADDED */
/******************************************************************/
Following is an explanation of the line that is executed in the LCU command file:
C:\OS2\INSTALL\DSPINSTL /pd:c:\os2\install\00S3.dsc
/S:X:\img\s3_drvs /T:C: /res:640x480x256 /u
/pd:c:\os2\install\00S3.dsc
is the dsc laid down during setup phase.
/S:X:\img\s3_drvs
where X:\img\s3_drvs is the redirected source path.
/T:C:
where C: is the drive where OS/2 is installed.
/res:640x480x256
is a resolution/color depth from the list of "Supported
Resolutions" that appears earlier in this README.
/u
means Unattended installation.
NOTES:
• Be sure you have the stated video memory required, as listed in "Supported
Resolutions" earlier in this README. A safe choice is 640x480x256. Any of
the listed resolutions can be selected, but your display might be damaged if you
select a resolution that your display does not support.
• To select a refresh rate, SVGA.EXE can be executed again separately after
DSPINSTL. Example, SVGA ON INIT 1024 75 This will create another
\OS2\VIDEO.CFG file with 75Hz as the default at 1024x768 resolution. The
prior \OS2\VIDEO.CFG file should be deleted first.
• After the Vision864/964/868/968/Trio32/64/64V+/64V2 device driver has been
successfully installed on the client machine using the CID method and the client
machine is restarted, the resolution will be as specified by command line argu-
ment.
• After the CID installation, refer the end user to section 6.0 "Installation from
Diskette," step 12.
IBM OS/2
IBM OS/2
A. VGA Driver