Iii. installation, Power connection procedures – Asus P2B-D2 User Manual
Page 37
ASUS P2B-D2 User’s Manual
37
III. INSTALLATION
Power Connections
III. INSTALLATION
Power Connection Procedures
1. After all connections are made, close the system case cover.
2. Be sure that all switches are off (in some systems, marked with ).
3. Connect the power supply cord into the power supply located on the back of
your system case according to your system user’s manual.
4. Connect the power cord into a power outlet that is equipped with a surge protector.
5. You may then turn on your devices in the following order:
a . Your monitor
b. External SCSI devices (starting with the last device on the chain)
c. Your system power. For ATX power supplies, you need to switch
on the power supply as well as press the ATX power switch on the
front of the case.
6. The power LED on the front panel of the system case will light. For ATX
power supplies, the system LED will light when the ATX power switch is
pressed. The LED on the monitor may light up or switch between orange and
green after the system’s if it complies with “green” standards or if it has a power
standby feature. The system will then run power-on tests. While the tests are
running, additional messages will appear on the screen. If you do not see any-
thing within 30 seconds from the time you turn on the power, the system may
have failed a power-on test. Check your jumper settings and connections or call
your retailer for assistance.
7. During power-on, hold down
tions in the next section, BIOS SOFTWARE.
*
Powering Off your computer: You must first exit or shut down your operating
system before switching off the power switch. For ATX power supplies, you
can press the ATX power switch after exiting or shutting down your operating
system. If you use Windows 95, click the Start button, click Shut Down, and
then click Shut down the computer?. The system will then power off after
Windows shuts down.
NOTE: The message “You can now safely turn off your computer” will not
appear when shutting down with ATX power supplies.