Asus TS100-E5/PI4 - Manual (Page 72)

4-16 Chapter 4: BIOS setup
The following three items appear only when the USB Functions item is set to
[Enabled].
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 controller.
Configuration options: [Enabled] [Disabled]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB. The AUTO option
disables legacy support if there is no USB device connected.
Configuration options: [Disabled] [Enabled] [Auto]
USB2.0 Controller mode [HiSpeed]
Allows you to set the USB2.0 controller mode to HiSpeed (480 Mbps) or
FullSpeed (12 Mbps).
Configuration options: [HiSpeed] [FullSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows yout to enable or disable the BIOS EHCI Hand-Off support function.
Configuration options: [Disabled] [Enabled]
4.4.2 Remote Access Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Select Remote Access
type.
Configure Remote Access type and parameters
Remote Access [Enabled]
Serial port number [COM1]
Base Address, IRQ [3F8h,4]
Serial Port Mode [115200 8, n,1]
Flow Control [None]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
VT-UTF8 Combo Key Support [Enabled]
Sredir Memory Display Delay [No Delay]
The items in this menu allows you to configure the Remote Access features. Select
an item then press to display the configuration options.
Remote Access [Disabled]
Enables or disables the remote access feature.
Configuration options: [Disabled] [Enabled]
The following items on the next page appear only when the Remote Access
item is set to [Enabled].