Pro Series 51093 51 Receiver - Manual

Installation Instructions
BMW X5
Part Numbers:
51093
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 8mm, 13mm, 17mm, T50, T55, 3/4
Drill Bits: 1/2”, 11/16”
REQUIRES REMOVAL OR
TRIMMING OF FASCIA DOOR
Rev. A 10-9-07 51093N Sheet 1 of 7 z 2007 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 51093F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 (272 Kg) 6000 (2724 Kg)
Weight Carrying
Ball Mount
600 (272 Kg) 6000 (2724 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SEE AUTO DEALER
Form: F205 Rev A 5-6-05
FASCIA
REMOVABLE DOOR
UTILITY KNIFE
1
2
3 *
4 *
5
6
7
8
FIGURE 1.
DRILLED
HOLE
USED TO INSTALL
RIVET NUT ONLY *
FORWARD ATTACHMENT
CROSSMEMBER
REAR ATTACHMENT
CROSSMEMBER
(SEE NOTE 10 & 11)
*
*
ANTI-SWAY BAR
BOTTOM VIEW
FIGURE 3.
REAR DIFFERENTIAL
1-1/8" FROM REAR EDGE
FORWARD
VEHICLE
CROSSMEMBER
FORWARD ATTACHMENT
(NOT IN CENTER)