SENA ProBee-ZU10 - Manual (Page 61)

61 ProBee-ZU10 User Guide Rev.1.5
Execute ATS37? ATS37=
Response
OK
OK
Default 0
Range 0 – 7
7.3.8 S38
Description
Get/Set the receive message mode. If it is enabled, a local node will receive multicast
or broadcast messages from itself.
Execute ATS38? ATS38=
Response
OK
OK
Default 0
Range 0 – 1
7.3.9 S39
Description
Get/Set the receive mode. If S39 is enabled, a local node will only receive the same
type of messages with its transmission mode. For example, if local node’s
transmission mode is broadcast mode (AT+TM=3), it will receive only broadcast
messages and won’t receive unicast or multicast messages.
Execute ATS39? ATS39 =
Response
OK
OK
Default 0
Range 0 - 1
7.4 End-Device
7.4.1 S51
Description
Get/Set the poll timeout for a parent node in seconds. If an end-device or a sleepy
end-device does not send a poll request to its parent coordinator or router within the
poll timeout, the end-device is removed from the child table.
Execute ATS51? ATS51=
Response
OK
OK
Default 60
Range 0 – 4177920
7.4.2 S52
Description Get/Set the sleepy end-device poll period in milliseconds. Adaptive polling may allow