SENA ProBee-ZU10 - Manual (Page 59)

59 ProBee-ZU10 User Guide Rev.1.5
range.
Execute ATS23? ATS23=
Response
OK
OK
Default 0
Range 0 – 1
7.3 Data Transmissions
7.3.1 S31
Description
Get/Set the application-ACK mode. If it is enabled, a sender node retransmits data
packet when it fails to receive ACK from receiver node. This value must be set same
on the source and destination node for data transmission.
Execute ATS31? ATS31=
Response
OK
OK
Default 1
Range 0 - 1
7.3.2 S32
Description
Get/Set the transmission retries. A sender tries to retransmit up to this value when
transmission fails. (CAUTION: It is recommended to set the smallest value that the
application can tolerate in broadcast/multicast data transmission.)
Execute ATS32? ATS32=
Response
OK
OK
Default 5
Range 0 – 99
7.3.3 S33
Description
Get/Set the transmission timeout in milliseconds. A sender retransmits data packet
after this time when transmission fails. (CAUTION: It is recommended to set this value
more than 1000 in broadcast/multicast data transmission.)
Execute ATS33? ATS33=
Response
OK
OK
Default 500
Range 0 – 10000