SENA ProBee-ZU10 - Manual (Page 58)

58 ProBee-ZU10 User Guide Rev.1.5
7.1.2 S12
Description Get/Set the command echo mode.
Execute ATS12? ATS12=
Response
OK
OK
Default 1
Range 0 – 1
7.1.3 S13
Description Get/Set the command responses mode.
Execute ATS13? ATS13=
Response
OK
OK
Default 1
Range 0 - 1
7.2 Network Settings
7.2.1 S21
Description
Get/Set the inter character timeout in milliseconds. It determines to send data packet
after this time.
Execute ATS21? ATS21=
Response
OK
OK
Default 100
Range 0 - 10000
7.2.2 S22
Description
Get/Set the timeout to permit joining. It determines the time in seconds that the device
will allow other devices to join to it when it starts network but an end-device cannot
perform it. If set to 255, the device will always permit joining.
Execute ATS22? ATS22=
Response
OK
OK
Default 255
Range 0 - 255
7.2.3 S23
Description
Get/Set the power boost mode of the adapter. If enabled, boost mode improves
sensitivity by 1dB and increases output power by 2dB, improving the link margin and