SENA ProBee-ZU10 - Manual (Page 52)

52 ProBee-ZU10 User Guide Rev.1.5
6 AT Command Examples
6.1 Network configuration
6.1.1 Coordinator
AT+NODETYPE=1 # set node type (coordinator)
OK # Response
ATZ # Apply the change
OK # Response
6.1.2 Router
AT+NODETYPE=2 # set node type (router)
OK # Response
ATZ # Apply the change
OK # Response
6.1.3 End-device
AT+NODETYPE=3 # set node type (end-device)
OK # Response
ATZ # Apply the change
OK # Response
6.1.4 Sleepy End-device
AT+NODETYPE=4 # set node type (sleepy end-device)
OK # Response
ATZ # Apply the change
OK # Response
6.1.5 Specifying Network
AT+CHMASK=1000 # set 32-bit channel mask (ch: 12)
OK # Response
AT+PANID=0001 # set 16-bit PAN ID (0001)
OK # Response
AT+EPID=0000000000000001 # set 64-bit extended PAN ID (0000000000000001)
OK # Response
AT+ADDRDISCOVERY=1FEF # get 64-bit address using 16-bit short address