SENA ProBee-ZU10 User Manual

Page 54

ProBee-ZU10 User Guide Rev.1.5

# Response

# send broadcast message(MSG04) to current network and the range is
determined by S35.

AT+BROADCAST=MSG04

# Response

6.2.2

Data Mode

ATD

# enter the unicast mode using destination long address

# Response

MSG05+++

# send data(MSG05) and leave data mode

ATD0000

# enter the unicast mode using 16-bit short address

# Response

MSG06+++

# send data(MSG06) and leave data mode

ATD00019500002FDC40

# enter the unicast mode using 64-bit long address

# Response

MSG07+++

# send data(MSG07) and leave data mode

ATM

# enter the multicast mode using destination group ID

# Response

MSG08+++

# send data(MSG08) and leave data mode

ATM0001

# enter the multicast mode using 16-bit group ID

# Response

MSG09+++

# send data(MSG09) and leave data mode

ATB

# enter the broadcast mode

# Response

MSG10+++

# send data(MSG10) and leave data mode

AT+TRANSMITMODE=1

# set transmission mode

# Response

ATZ

# Apply the change

# Response

MSG11+++

# send data(MSG11) and leave data mode

ATO

# return to the current data mode

6.3

Security

AT+SECURITY=1

# set security level (ON)

# Response

AT+LINKKEY=5A46…21

# set the 128-bit trust center link key (5A46…21)