Ocean Optics External Triggering Options Instructions for Spectrometers with Firmware Version 3.0 and Above - Manual (Page 4)

External Triggering Options Instructions for FW 3.0 and Above
4 200-00000-001-01-201401
The integration time may also be set manually by using the numeric spinner control and the drop-down
units menu. Note that the Nonlinearity Correction control is grayed out until the Electric Dark control
is enabled. Also note that once a triggering mode for the spectrometer has been set, the device will wait
for an external trigger before continuing. It will appear as though the spectrometer has locked up and no
further data acquisitions will occur until the External Trigger pin on the device receives a signal.
Set Integration Time with SpectraSuite
Use the External Trigger selection box on the Trigger toolbar to set the trigger mode of the spectrometer
to Software.