Littelfuse SP1007 Series - Manual (Page 2)

© 2013 Littelfuse, Inc.
Specifications are subject to change without notice.
Revised: 11/22/13
TVS Diode Arrays
(SPA ® Diodes)
General Purpose ESD Protection - SP1007 Series
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of
the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Absolute Maximum Ratings
Symbol Parameter Value Units
I
PP
Peak Current (t
p
=8/20μs) 2.0 A
T
OP
Operating Temperature –40 to 125 °C
T
STOR
Storage Temperature –55 to 150 °C
Electrical Characteristics (T
OP
=25ºC)
Note:
1 Parameter is guaranteed by design and/or device characterization.
Thermal Information
Parameter Rating Units
Storage Temperature Range –55 to 150 °C
Maximum Junction Temperature 150 °C
Maximum Lead Temperature (Soldering 20-40s) 260 °C
Parameter Symbol Test Conditions Min Typ Max Units
Reverse Standoff Voltage V
RWM
6.0 V
Breakdown Voltage V
BR
I
R
=1mA 8.5 9.5 V
Leakage Current I
LEAK
V
R
=5V with 1 pin at GND 0.1 0.5 μA
Clamp Voltage 1 V
C
I
PP
=1A, t
p
=8/20µs, Fwd 11.2 V
I
PP
=2A, t
p
=8/20µs, Fwd 13.1 V
Dynamic Resistance R
DYN
(V
C2
- V
C1
) / (I
PP2
- I
PP1
) 1.9 Ω
ESD Withstand Voltage 1 V
ESD
IEC61000-4-2 (Contact Discharge) ±8 kV
IEC61000-4-2 (Air Discharge) ±15 kV
Diode Capacitance 1 C
D
Reverse Bias=0V 5 6 pF