QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 32)

Configuring PPP and PPPoE
[local]Redback(config)#ppp ipcp negotiate netmask
[local]Redback(config)#context PPP
[local]Redback(config-ctx)#interface ppp multibind
[local]Redback(config-if)#ip address 10.10.10.1/24
[local]Redback(config-if)#exit
[local]Redback(config-ctx)#interface to_rad
[local]Redback(config-if)#ip address 1.1.1.2/24
[local]Redback(config-if)#exit
[local]Redback(config-ctx)#aaa authentication subscriber radius
[local]Redback(config-ctx)#aaa accounting subscriber radius
[local]Redback(config-ctx)#aaa provision route ip-netmask encapsulation pppoe
[local]Redback(config-ctx)#radius server 1.1.1.1 key key
[local]Redback(config-ctx)#radius accounting server 1.1.1.1 key key
[local]Redback(config-ctx)#exit
[local]Redback(config)#port ethernet 2/15
[local]Redback(config-port)#no shutdown
[local]Redback(config-port)#encapsulation dot1q
[local]Redback(config-dot1q-pvc)#dot1q pvc 100 encapsulation pppoe
[local]Redback(config-dot1q-pvc)#exit
[local]Redback(config-port)#bind authentication chap pap context PPP maximum 10
[local]Redback(config-port)#exit
[local]Redback(config)#port ethernet 2/21
[local]Redback(config-port)#no shutdown
[local]Redback(config-port)#bind interface to_rad PPP
5.2.6 Verify Reserved IP Addresses or Subnets and Installed Routes
To verify the IP addresses or subnets reserved for subscribers, use the show
subscribers active
command; to verify the installed routes, use the show
ip route command.
The examples in this section assume the following local and RADIUS IP
address configuration:
context local
…
interface ppp multibind
ip address 21.22.23.180/24
ipv6 address 2001:1:2::/48
…
RADIUS record on the RADIUS server:
…
Framed-IP-Address = 21.22.23.25,
Framed-IP-Netmask = 255.255.255.252
28 64/1543-CRA 119 1170/1 Uen K | 2012-12-04