QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 24)

Configuring PPP and PPPoE
Table 15 Configure a Subscriber Record for PPPoE
Step Task Root Command Notes
Create a PPPoE MOTM
and enable the sending of
it to subscribers. pppoe motm
Point a subscriber’s
PPPoE client browser to a
specified URL. pppoe url
For descriptions of the basic tasks needed to configure a subscriber record, see
the document, Configuring Subscribers.
3.2.8 Configure IPCP Netmask Negotiation
To enable IPCP netmask negotiation different from the default, configure
the ppp ipcp negotiate netmask command in global configuration mode and
perform one of the following tasks:
• To reserve an entire subnet range and install the subnet route, configure
the aaa provision route command, without the use-framed-route
keyword.
For example, use the aaa provision router ip-netmask
encapsulation pppoe
construct of the command.
• To reserve one IP address and install the subnet route, configure the ppp
ipcp negotiate netmask
command and the aaa provision route
command with the use-framed-route keyword.
For example, for PPPoE use the aaa provision route ip-netmask
encapsulation pppoe use-framed-route
construct of the
command.
By default, the SmartEdge OS sends an IPCP ConfRej message for netmask
requests without one of these configurations.
3.2.9 Configure MLPPP over PPPoE
To configure MLPPP using PPPoE, perform the tasks described in Table 16.
Enter all commands in global configuration mode.
Table 16 Configure MLPPP over PPPoE
Step Task Root Command Notes
1. Enable PPP multilink. ppp multilink
2. Optional. Specify the
endpoint discriminator. ppp our-options mru
20 64/1543-CRA 119 1170/1 Uen K | 2012-12-04