QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 25)

Configuration Tasks
Table 16 Configure MLPPP over PPPoE
Step Task Root Command Notes
3. Optional. Specify priority and
fragmentation threshold value
for subscriber sessions. ppp multilink lfi
4. Configure one or more PPPoE
encapsulated Ethernet ports. For the commands
to configure a PPPo
E-encapsulated
Ethernet port, see
Table 10.
3.2.10 Example: MLPPP Configuration on PPPoE
The following example shows how to configure MLPPP on PPPoE with two
PPPoE sessions for the subscriber. The configuration below results in two
active PPP links for an MLPPP subscriber on port 3/1 and port 3/2. The PPPoE
client negotiates the same endpoint discriminator for both links:
!Configure PPP multilink global attributes
[local]Redback(config)#ppp multilink
[local]Redback(config)#ppp our-options multilink endpoint-discriminator local-ip-address
!Configure the links
[local]Redback(config)#port ethernet 3/1
[local]Redback(config-port)#encapsulation pppoe
[local]Redback(config-port)#bind authentication chap pap
[local]Redback(config-port)#exit
[local]Redback(config)#port ethernet 3/2
[local]Redback(config-port)#encapsulation pppoe
[local]Redback(config-port)#bind authentication chap pap
[local]Redback(config-port)#exit
!Configure the subscriber
[local]Redback(config)#context local
[local]Redback(config-ctx)#subscriber joe
Other documents with related commands include:
•
•
• Configuring Circuits
• Configuring Cross-Connections
Note: An 802.1Q permanent virtual circuit (PVC) is also referred to as an
802.1Q virtual LAN (VLAN), but in this document, it is the circuit
that is being configured.
21 64/1543-CRA 119 1170/1 Uen K | 2012-12-04