QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 18)

Configuring PPP and PPPoE
Table 7 Configure MLPPP on ATM PVCs
Step Task Root Command Notes
1. Enable PPP multilink. ppp multilink
2. Specify the endpoint
discriminator. ppp our-options mult
ilink
3. Optional. Specify priority
and fragmentation
threshold value for
subscriber sessions. ppp multilink lfi
4. Configure one or more
PPP-encapsulated ATM
PVCs. For the commands
to configure a
PPP-encapsulated ATM
PVC, see Table 4.
3.1.7 Example: MLPPP Configuration on ATM PVCs
The following example shows how to configure MLPPP on PPP-encapsulated
ATM PVCs using the IP address of the Ethernet management port, two ATM
PVCs with identical configuration on the ATM traffic card in slot 3, and a
subscriber with a limit of 2 sessions:
!Configure PPP multilink global attributes with IP address of Ethernet management port
[local]Redback(config)#ppp multilink
[local]Redback(config)#ppp our-options multilink endpoint-discriminator local-ip-address
!Configure the links
[local]Redback(config)#port atm 3/1
[local]Redback(config-port)#atm pvc 200 100 profile adsl encapsulation ppp
[local]Redback(config-pvc)#bind authentication chap pap
[local]Redback(config-pvc)#exit
[local]Redback(config-port)#exit
[local]Redback(config)#port atm 3/2
[local]Redback(config-port)#atm pvc 200 200 profile adsl encapsulation ppp
[local]Redback(config-pvc)#bind authentication chap pap
[local]Redback(config-pvc)#exit
[local]Redback(config-port)#exit
!Configure the subscriber
[local]Redback(config)#context local
[local]Redback(config-ctx)#subscriber joe
[local]Redback(config-sub)#port-limit 2
3.1.8 Configure MLPPP for L2TP Subscribers
To configure MLPPP for L2TP subscribers, perform the tasks described in
Table 8. Enter all commands in global configuration mode.
Table 8 Configure MLPPP for L2TP Subscribers
Step Task Root Command Notes
1. Enable PPP multilink. ppp multilink
14 64/1543-CRA 119 1170/1 Uen K | 2012-12-04