QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 21)

Configuration Tasks
Table 10 Configure an PPPoE-Encapsulated Ethernet Port
Step Task Root Command Notes
1. Encapsulate the Ethernet
port. encapsulation
(POS) Specify the encapsulation type as
pppoe
.
2. Bind the port with one of the following tasks:
Create an unrestricted
dynamic binding. bind authenticati
on You must specify the context to create
a restricted dynamic binding.
Create a restricted
dynamic binding. bind authenticati
on You must specify the context to create
a restricted dynamic binding.
3.2.3 Configure a PPPoE-Encapsulated ATM PVC
To configure a PPPoE-encapsulated ATM PVC, perform the tasks described
in Table 11.
Table 11 Configure a PPPoE-Encapsulated ATM PVC
Step Task Root Command Notes
1. Create one or more
PPPoE-encapsulated
ATM PVCs and access
ATM PVC configuration
mode. atm pvc Enter this command in ATM OC
configuration mode.
Use the explicit keyword to
create a range of PVCs.
Use the on-demand keyword to
configure a range of PVCs that are
created only when needed.
Specify the encapsulation type as
pppoe
.
2. Bind the ATM PVC with one of the following tasks:
Create an unrestricted
dynamic binding. bind authentication
Create a restricted
dynamic binding. bind authentication You must specify the context to
create a restricted dynamic binding.
3.2.4 Configure a PPPoE-Encapsulated 802.1Q PVC
To configure a PPPoE-encapsulated 802.1Q PVC, perform the tasks described
in Table 12.
17 64/1543-CRA 119 1170/1 Uen K | 2012-12-04