QTECH SmartEdge 100 PPP and PPPoE - Manual (Page 22)

Configuring PPP and PPPoE
Table 12 Configure a PPPoE-Encapsulated 802.1Q PVC
Step Task
Root Comman
d
Notes
1. Create a PPPoE-enca
psulated 802.1Q PVC
and access dot1q PVC
configuration mode. dot1q pvc Enter this command in port
configuration mode.
Specify the encapsulation type as
pppoe
.
2. Bind the 802.1Q PVC with one of the following tasks:
Create an unrestricted
dynamic binding. bind authenticati
on
Create a restricted
dynamic binding. bind authenticati
on You must specify the context to create
a restricted dynamic binding.
3.2.5 Configure a PPPoE-Encapsulated Child Circuit on an ATM PVC
To configure a child circuit on an ATM PVC for PPPoE, perform the tasks
described in Table 13.
Table 13 Configure a PPPoE-Encapsulated Child Circuit on an ATM PVC
Step Task
Root Comman
d
Notes
1. Create one or more parent
ATM PVCs and access
ATM PVC configuration
mode. atm pvc Enter this command in ATM OC
configuration mode.
Use the explicit keyword to create
a range of PVCs.
Specify the encapsulation type as
multi
.
2. Create the PPPoE-enca
psulated child circuit and
access ATM child protocol
configuration mode. circuit protocol Specify the encapsulation type as
pppoe
.
3. Bind the child circuit with one of the following tasks:
Create an unrestricted
dynamic binding. bind authentica
tion
Create a restricted
dynamic binding. bind authentica
tion You must specify the context to create
a restricted dynamic binding.
18 64/1543-CRA 119 1170/1 Uen K | 2012-12-04