dbx DriveRack PA+ - Manual (Page 33)

Use Wheel to Change Restart Preset Number
Turning the Data Wheel will select the preset you wish to load at initial power-up. •
Press the PRESET/RECALL button again when the selection is complete. Normal startup •
will continue.
System Lock Out
Press and hold the RTA button at power-up until one of the following messages appears: •
System Unlocked All user input will be accepted
or
System Locked No user input will be accepted
or
System Locked with AFS Filter Clear
Rotate the Data Wheel to select either Lock, Unlock or Filter Unlocked. •
Pressing PREV PG will unlock the system if it were locked or it will lock the system if it •
were unlocked.
If you wish to leave the system locked with the exception of being able to clear the
•
feedback filters, follow the same procedure on power up and then rotate the Data Wheel
to select the feedback filter unlock feature.
Pressing any other button will abort the System Lockout sequence and the unit will reset
•
normally.
A.4 Update Firmware
For information on updating the DriveRack® PA+ firmware via USB, visit the Products page at
www.dbxpro.com and select DriveRack PA+. New firmware update links will be posted when
available.
A.5 Preset List/Speaker Tunings
For the latest lists of presets and supported speaker tunings, visit the Products page at
www.dbxpro.com.
Section A
Appendix
29
DriveRack
®
PA+