dbx DriveRack PA+ - Manual (Page 32)

Section A - Appendix
A.1 Factory Reset
In the event that a reset is required, the DriveRack® PA+ offers you the option of performing
a “Soft” or “Hard” reset. The Soft Reset resets all operating parameters except user presets.
The Hard Reset Procedure will reset all presets information back to the factory defaults.
A.2 DriveRack PA+ Power-Up Button Functions
All Power-Up Functions require a button(s) to be pressed and held as the unit power is turned
on.
Factory (“Hard”) Reset.
Press and hold the STORE button at power-up until the following message appears:
“! HARD RESET?”
“Yes ”
“No ”
Pressing the PREV PG button will start a Factory Reset (All User Presets will be restored to •
the Factory Presets, all Utility settings will be defaulted, and all Security settings will be
defaulted).
Pressing the PRESET/RECALL button will abort the Factory Reset sequence and the unit
•
will reset normally.
System (“SOFT”) Reset
Press and hold the UTILITY button at power-up until the following message appears: •
“! SOFT RESET?”
“Yes ”
“No ”
Pressing the PREV PG button will start a System Reset (All Utility settings will be •
defaulted.)
Pressing the PRESET/RECALL button will abort the System Reset sequence and the unit
•
will reset normally.
A.3 Power Up Quick Key Options
The DriveRackPA+ offers several “Quick Key” options for initial power up and are as follow:
Change Initial Preset Number
To change the initial power up preset number, Press and hold the PRESET/RECALL button •
at power-up until the following message appears:
Section A
Appendix
28
DriveRack
®
PA+