dbx DriveRack PA+ - Manual (Page 19)

4.3 Editing Factory Presets
To edit the currently loaded factory preset, press a module’s button (COMP/LIMITER, for
example), then use the PREV PG and NEXT PG buttons to move through the pages within the
module. Turn the Data Wheel to edit parameter values. The following illustration shows an
example of the Comp module in edit mode:
Over Easy OFF
Compressor ON
COMP THR -50 -30 -12 -5 0
LR - 0+
Note that the arrow indicates the currently selected parameter for editing. To select
parameters to edit from the current page, simply press the Data Wheel until the arrow is
pointing to the parameter that you wish to edit.
4.4 Saving Presets
Once you are satisfied with the changes that have been made to a factory or user preset, the
DriveRack® PA+ allows you to save these changes as a custom USER preset. Press the STORE
button, the display will appear as follows:
DATA - SELECTS CHAR
PREV/NEXTPG - LEFT/RIGHT:
PRESS STORE TO ADVANCE
NAME: R OCK VENUE
Rotating the Data Wheel will change characters in the currently selected position. •
Pressing the Data Wheel will toggle between upper and lowercase letters, numbers or •
symbols.
Use the PREV PG and NEXT PG button to move character positions. •
Once the desired title has been written, press the STORE button again and the display will •
now appear something like this:
Replacing
PRESS STORE TO ADVANCE
STORE: ROCK VENUE
U1 DJ Setup
Rotate the Data Wheel to select the user preset number to be replaced. Press the STORE •
button again and the existing preset will be replaced with the new preset.
Section 4
Operating Functions
15
DriveRack
®
PA+