Disposal, Certification and safety approvals – Sena Bluetooth SMH10 v5.0 User's Guide User Manual
Page 49

SMH10
50
DISPOSAL
The crossed-out wheel bin symbol on the product, 
literature, or packaging reminds you that all electrical 
and electronic products, batteries, and accumulators 
must be taken to separate collection at the end of their 
working life. This requirement applies to the European 
Union and other locations where separate collection 
systems are available. To prevent possible harm to the environment 
or human health from uncontrolled waste disposal, please do not 
dispose of these products as unsorted municipal waste, but hand it in 
at	an	official	collection	point	for	recycling.	
CERTIFICATION AND SAFETY APPROVALS
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is 
subject	to	the	following	two	conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including 
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the 
interference	by	one	or	more	of	the	following	measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that 
