Sena Bluetooth SMH10 v5.0 User's Guide - Manual (Page 18)

SMH10
19
English
5. The intercom pairing queue is ‘Last-Come, First-Served’. If a
headset has multiple paired headsets for intercom conversations,
the last paired headset is set as first intercom friend. The
previous intercom friend becomes second intercom friend, and
third intercom friend.
Note:
For example, after the pairing procedures listed above, headset D is the first
intercom friend of headset A. Headset C is the second intercom friend of
headset A, and headset B is the third intercom friend of headset A.
8.2 Pairing with Other Sena Headset Models for Intercom
Conversation
The SMH10 can be paired with all other Sena headset models such
as the SMH5 and the SPH10 for intercom conversation. Please follow
the same procedure as above to pair with these headset models.
Note:
The SMH5 cannot participate in three-way or four-way conference intercom
with the SMH10 or the SPH10. The SMH5 has a limited capability of having
two-way intercom with each other or with other Sena headsets such as the
SMH10 and the SPH10.
You can set the configuration of the SMH10 by the voice menu
instruction as below.
1. To enter into voice configuration menu, press and hold the Jog
Dial for 12 seconds until the LED shows solid blue and you hear
high tone double beeps. You will also hear a voice prompt saying
“Configuration menu”.
2. Rotate the Jog Dial clockwise or counter-clockwise to navigate
between the menus. You will hear voice prompts for each menu
items as below.
3. You can enable the feature or execute the command by tapping
the Phone Button, or disable the feature by tapping the Jog Dial.
4. If any button is not pressed within 10 seconds, the SMH10 will exit
the configuration and goes back to stand-by mode.
5. If you want to exit the configuration immediately, rotate the Jog
Dial until you hear a voice prompt saying “Exit configuration”,
and tap the Phone Button.
9. SMH10 CONFIGURATION SETTING