Sena Bluetooth SMH10 v5.0 User's Guide - Manual (Page 21)

SMH10
22
9.4 Enabling/Disabling Voice Prompts
Voice Prompt “Voice prompt”
Factory Default Enable
Enable Tap the Phone Button
Disable Tap the Jog Dial
You can disable voice prompts by configuration setting, but the
following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
9.5 Enabling/Disabling Sidetone
Voice Prompt "Sidetone"
Factory Default Disable
Enable Tap the Phone Button
Disable Tap the Jog Dial
Sidetone is the sound of your own voice as picked up by your
headset’s microphone and reproduced in your own ear, by your own
speaker. It helps you to naturally speak at the correct level according
to varying helmet noise conditions. If this feature is enabled, you can
hear what you are speaking during an intercom conversation or a
phone call.
9.6 Delete all Bluetooth Pairing Information
Voice Prompt “Delete all pairings”
Factory Default N/A
Execute Tap the Phone Button
To delete all Bluetooth pairing information of the SMH10, rotate the
Jog Dial until you hear a voice prompt saying “Delete all pairings”,
and tap the Phone Button to confirm. Taping the Jog Dial is not
available for this setting.
9.7 Exit Voice Configuration Menu
Voice Prompt “Exit configuration”
Factory Default N/A
Execute Tap the Phone Button
To exit voice configuration menu and get back to stand-by mode,
rotate the Jog Dial until you hear a voice prompt saying
“Exit
configuration”, and tap the Phone Button to confirm. Tapping the
Jog Dial is not available for this setting.