PowerWalker Battery Pack for VFI 1000RT LCD - Manual (Page 24)

20
EN
(2) UPS Output Connection
The output of the UPS is IEC socket-types. Simply plug the load power cord
to the output sockets to complete connection. Use one cord for every 5A
load.
Model No. Output Socket (pcs)
1K(S)/1.5K(S)/ 2K(S) 8 * IEC320 C13
3K(S) 8 * IEC320 C13 + 1 * C19
The wiring configuration is shown as the
following procedure:
a) Remove the small cover of the terminal block
b) Use 2.5mm
2
wires for wiring configuration
c) Upon completion of the wiring configuration,
please check whether the wires are securely
affixed
d) Put the small cover back to the rear panel
(3) EPO Connection:
User can select the polarity of EPO, EPO is Normally open as default setting.
NO
Normally the EPO connector is open on the rear panel. Once the connector is
closed with a wire, the UPS would stop the output until the EPO status is disabled.
Disable the EPO status Enable the EPO status
Connection diagram
Caution:
Do not connect equipment which would overload the UPS system (e.g. laser
printers)