PowerWalker Battery Pack for VFI 1000RT LCD User Manual

Page 11

Connecting the EBM in a rack form

1. Using the same method as assembling UPS in a rack form, assemble EBM

into the rack-mounting on the top or bottom of the UPS.

2. Connect the earth line from UPS (port A ) to EBM (port B )

3. Take off the LCD box, and unscrew the internal screws.

4. Take off the front panel, and connect the battery terminal (A) from UPS to

EBM terminal (B) shown as below. Users need to remove the small gate(C)

on side of the front panel to allow the outlet wire of the EBM to pass through

the gate and then reassemble front panel.

5. After installing the UPS into rack, the load can then be connected to UPS.

Please make sure the load equipment is turned off before plugging all loads

into the output receptacle

Connecting the Multiple EBMs

1000VA/1500VA/2000VA and 3000VA UPS include external battery port that
allows users to connect multiple EBM in order to provide additional backup
time. Follow the procedure to install multiple EBM as below.

Unscrew