beautypg.com

Show or set port configuration, Cli commands, continued – B&B Electronics 7506GX2-SX - Manual User Manual

Page 140

background image

(Revised 2010-7-30)

Page 140 of 158

CLI Commands, Continued…

Show or Set Port Configuration

Command Name

Port

Description

Show or set Port configuration.

Syntax

port [-show] [-admin state] [-sd auto | 10h | 10f | 100h | 100f | 1000h | 1000f]
[-flow state] [-fhp state] [-dp prio] [-dscp state] [-8021p state] [-pvid vid]
[-ual percent] [-uah percent] [-security state] portno

Parameters

Portno

Port number to configure or show. Specify ―all‖ to show all ports.

-show

Show configuration.

-admin state

Set the admin status for the port to e(nabled) or d(isabled).

-sd

Set the speed and duplex mode for the port.
auto = enable auto-negotiation

-flow state

Set the flow control for the port to e(nabled) or d(isabled).

-fhp state

Set force high priority for the port to e(nabled) or d(isabled).

-dp

Set the default QOS priority for the port. The range is 0-7.

-dscp state

Set the DSCP Priority for the port to e(nabled) or d(isabled).

-8021p state

Set the 802.1p Priority for the port to e(nabled) or d(isabled).

-pvid

Set the VLAN ID for the port. The range is 1-4094.

-ual percent

Set the usage alarm low percentage. The range is 0-100.

-uah percent

Set the usage alarm high percentage. The range is 0-100.

-security state

Set the security status for all supported ports to e(nabled) or d(isabled).

Examples

N-TRON/Admin> port –sd 100f –flow enabled –dp 7 –pvid 2 4

Port Port Admin Link Auto Port Dupl Flow Force Include Include
No Name Status Stat Nego Spd Mode Control High Pri DSCP 802.1p
---- ---- -------- ---- -------- ---- ---- -------- -------- -------- --------
4 T4 Enabled Down Disabled 100 Full Enabled Disabled Disabled Enabled

Usage Usage
Def Port Alarm Alarm
Pri State PVID Low % High %
7 Forwarding 2 0 100

Changes have been made that have not been saved.

NOTES