B&B Electronics 9000BP - Manual - Manual (Page 97)

(Revised 8/4/2009) page 97 of 145
“$”
Command Name $
Description This command copies the command identified by reference number
from the history list into the next command line
allowing the user to edit the command for corrections or changes.
Syntax $
Parameters n
The reference number of the command in the history list
that has to be edited.
Examples
N-TRON/Admin#[1]> whoaim
As shown above the command whoaim was entered instead of whoami.
To edit the already entered command do as follows.
N-TRON/Admin#[2]> $1
N-TRON/Admin#[2]> whoaim
Now we can edit the command at the command prompt.
NOTES After entering ‘$1’ at the prompt, it displays the previously entered
command.
Whoami
Command Name whoami
Description This command displays the current operating mode of the user.
Syntax whoami
Parameters None
Examples eg.1
N-TRON/Admin#[5]>whoami
admin with privilege of Administrator
eg.2
N-TRON/User#[5]> whoami
user with privilege of User
NOTES
Ping
Command Name ping
Description To issue the ping request to a specified host.
Syntax ping [count]
Parameters hostip-address
IP Address of the host to give the ping request.
count
Count the number of times to give the ping request (range 5-50).
Example
ping 10.1.6.15
ping 10.1.6.15 10
Notes