B&B Electronics 9000BP - Manual - Manual (Page 15)

(Revised 8/4/2009) page 15 of 145
APPLYING POWER (Side View)
• Unscrew & Remove the DC Voltage Input Plug
from the Power Input Header
• Install the DC Power Cables into the Plug
(observing polarity).
• Plug the Voltage Input Plug back into the Power
Input Header.
• Tightening torque for the terminal block power
plug is 0.5 Nm/0.368 Pound Foot.
• Verify the Power LED stays ON (GREEN).
Note: Only 1 power supply must be connected to power for minimal operation. For redundant power
operation, V
1
and V
2
inputs must be connected to separate DC Voltage sources. This device will draw
current from both sources simultaneously. Use 16-28 gauge wire when connecting to the power supply.
Recommended 24V DC Power Supplies, similar to: N-Tron’s P/N NTPS-24-5 (NOTE: Not appropriate for
use with M12, POE, and HV models.)
• Input AC 100V…240V
• Output DC 24V…28V
• Output Current 5A
• Peak Current 7.5A for 4 sec.
• Power 120W
• Peak Power 180W (max 4 sec.)
• 35 mm DIN-Rail Mountable
• Dimensions: 1.57”W x 4.88”H x 4.61”D