B&B Electronics DSC-200_300 - Manual - Manual (Page 33)

6.2.1 QTPCI.EXE
Quatech's "QTPCI" utility supplies the information required when modifying the serial port
settings of the application. This program should be run from real DOS, not in a Windows DOS
box.
Figure 13 shows the Basic Mode display for the DSC-200/300 after the "Q" key has been
pressed. In this example, the DSC-200/300 uses I/O base address FFA0 hex and IRQ 3. The
hardware revision of the DSC-200/300 is also displayed. Pressing the "N" key will show similar
information for all non-Quatech PCI devices in the system, including those devices integrated on
the motherboard.
The QTPCI program is capable only of displaying the PCI configuration. It cannot be used
to make changes.
Figure 13 --- QTPCI.EXE Basic Mode display
Quatech DSC-200/300 User's Manual 31