B&B Electronics LDVDSV2-S-P9D - Manual - Manual (Page 28)

OBDII Streamer Command & Response
V2.11
Page 28/49
0x24 – REDETECT_VEHICLE
Description:
This command will force all detected vehicle information to be redetected. The
REDETECT_VEHICLE command should only be required if the Streamer is removed
from one vehicle and moved to another or after exiting Bypass mode to ensure correct
vehicle-specific data is stored in non-volatile memory. Issuance of this command will
cause Streamer to wake up if it was in Standby mode.
Command to Send:
0x01 0x01 0x24 0x00 0x26
Response:
0x01 0x01 0xA4 0x00 0xA6
This response will be transmitted immediately. When the detection process is finished
the DEVICE_CONFIGURED message will be transmitted.
Example:
TX: 0x01 0x01 0x24 0x00 0x26
RX: 0x01 0x01 0xA4 0x00 0xA6
-Received immediately
The configuration time may take up to 1 minute to complete. Any requests during this
time will be responded to with a VEHICLE_NOT_DETECTED message.
RX: 0x01 0x01 0x80 0x00 0x82
-DEVICE_CONFIGURED message