Rainbow Electronics GE863-PY - Manual (Page 60)

GE863 Hardware User Guide
1vv0300783 Rev.0 - 10/06/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 60 of 80
8.9 Using the Temperature Monitor Function
8.9.1 Short Description
The Temperature Monitor is a function of the module that permits to control its internal
temperature and if properly set (see the #TEMPMON command on AT Interface guide) it raise
to High Logic level a GPIO when the maximum temperature is reached.
8.9.2 Allowed GPIO
The AT#TEMPMON set command could be used with one of the following GPIO:
Ball Signal Function Type
Input /
output
current
Note
34 GPIO 01 GPIO01 Configurable GPIO CMOS 2.8V 1uA / 1mA
6 GPIO 08 GPIO08 Configurable GPIO CMOS 2.8V 1uA / 1mA
5 GPIO 09 GPIO09 Configurable GPIO CMOS 2.8V 1uA / 1mA
4 GPIO 10 GPIO10 Configurable GPIO CMOS 2.8V 1uA / 1mA
1 GPIO 13 GPIO13 Configurable GPIO CMOS 2.8V 1uA / 1mA
60 GPIO 14 GPIO14 Configurable GPIO CMOS 2.8V 1uA / 1mA
71 GPIO 15 GPIO15 Configurable GPIO CMOS 2.8V 1uA / 1mA
64 GPIO 16 GPIO16 Configurable GPIO CMOS 2.8V 1uA / 1mA
59 GPIO 17 GPIO17 Configurable GPIO CMOS 2.8V 1uA / 1mA
76 GPIO 18 GPIO18 Configurable GPIO CMOS 2.8V 1uA / 1mA
The set command could be used also with one of the following GPIO but in that case the
alternate function is not usable:
Ball Signal Function Type
Input /
output
current
Note
33 GPIO 02 GPIO02 Configurable GPIO CMOS 2.8V 1uA / 1mA Alternate function (JDR)
53 GPIO 05 GPIO05 Configurable GPIO CMOS 2.8V 1uA / 1mA
Alternate function
(RFTXMON)
51 GPIO 07 GPIO07 Configurable GPIO CMOS 2.8V 1uA / 1mA Alternate function (BUZZER)