Rainbow Electronics GM862-QUAD-PY - Manual (Page 54)

Easy GPRS User Guide
80000ST10028 Rev. 4 - 16/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 54 of 63
4.2 Commands Overview
This paragraph describes the configuration and the activation of a command mode connection and the
AT commands implemented to use the new configuration socket parameters.
For anything concerning outgoing and incoming connections, you can refer to the chapter “Enhanced
Easy GPRS Extension“: there are no differences at sockets level.
NOTE: For more detailed AT commands and parameters definitions consult the AT Commands
Reference Guide.
4.2.1 Opening a socket connection in command mode
To open a socket in command mode we must use the multisocket commands AT#SD or AT#SA.
After a PDP context activation with AT#SGACT it is possible to open all sockets associated to this
PDP context in command mode using:
AT#SD=,,,[,[,],1]]
In case of listening, after an unsolicited indication for an incoming connection
SRING:
we have to use:
AT#SA = ,1
where the last parameter of AT#SD and AT#SA is . Default value is 0 which means
“classic” online mode, 1 is used for command mode.
Examples:
Open a command mode socket on connection Id number 1:
AT#SD =1,0,10510,”88.37.127.146”,0,0,1
OK
After an unsolicited indication for an incoming connection on a listening connId:
SRING: 1
AT#SA = 1,1
OK