2 ftp operations, 1 opening and closing an ftp connection – Rainbow Electronics GM862-QUAD-PY User Manual
Page 31

Easy GPRS User Guide
80000ST10028 Rev. 4 - 16/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 31 of 63
2.2 FTP OPERATIONS
A set of AT commands is available to support the FTP activities. The first command is called #FTPTO
(FTP Time-Out) which defines the time-out for FTP operations. The module has already a factory
default time defined that is 10 s.
If it is needed to be modified, the syntax is:
AT#FTPTO[=
Parameter:
100..5000 - hundreds of ms (factory default is 100)
NOTE: The parameter is not saved in NVM.
NOTE: if parameter
Example:
AT#FTPTO=1000
(set the timeout to 100sec)
OK
2.2.1 Opening and Closing an FTP Connection
With the command AT#FTPOPEN=
open the FTP connection.
The parameters are:
1 - passive mode
In order to close the FTP connection the AT command AT#FTPCLOSE should be used.