beautypg.com

Installation and setup – Cobalt Digital COMPASS 9341 8-channel Analog Audio to AES Converter User Manual

Page 25

background image

9341-OM (V4.1)

9341 PRODUCT MANUAL

2-3

Installation and Setup

Installing the 9341 Into a Frame Slot

Note:

External frame sync reference signals are received by the card over a refer-
ence bus on the card frame, and not on any card rear I/O module connectors.
The frame has BNC connectors labeled REF 1 and REF 2 which receive the
reference signal from an external source such as a house distribution.

Note:

The 9341 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.

10.

If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Setting Up 9341 Network Remote Control (p. 2-6).

Note:

If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.