Turbosmart BOV ADAPTERS - Nissan Skyline R32 User Manual
Page 2
SKYLINE R32 GTS-T BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia
Ph: +61(2) 9798 2866
Fax: +61 (2) 9798 2826
Email:
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA
Ph: (760) 727 7610
Fax: (760) 727 7963
Email:
PART NUMBER
FG-ADM-R32
Step 5. Release the adaptor elbow from the adaptor
flange by loosening the 3 lock nuts using an 8mm
socket. Then loosen the 3 grub screws using a 2.5mm
Allen key. Place the factory bolts into the flange holes
and reassemble the adaptor by tightening the grub
screws and lock nuts as shown below.
Step 6. Place the supplied Turbosmart gasket between
the flange and adaptor. Secure the R32 Adaptor to the
flange using the two factory bolts with a 12mm socket or
wrench.
Step 7. Install your Turbosmart BOV onto the R32
Adaptor by following the instructions included with the
BOV.
Step 8. Block off the factory return pipe with the supplied
blank and the factory return hose.
Step 9. Connect the remaining end of the Silicon hose
assembly to the Turbosmart BOV fitting. Secure the
fitting with the 5mm hose spring clamp supplied.
TROUBLE SHOOTING
The following points should be checked if you find that your engine is
dipping below normal idle, stalling or if the BOV is functioning poorly.
Please note the following checks will cure 99% of problems
experienced with fitting your BOV.
-
Check that the O-ring on the base of the BOV is fitted correctly
and is in good condition.
-
Ensure that the grub screws and lock-nuts are tightened on the
Remove
R32 Adaptor
R32 Adaptor
Turbosmart
BOV
Adaptor
Elbow
Adaptor
Flange
Factory
bolts
Grub screw
and lock nut
Blank off
factory return
pipe
400mm
5mm Silicon Hose Assembly