Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for: Mazdaspeed_MPS 3, 6 and CX7 User Manual
How to install your bov

1
------------------------------------------------------------------------------------------------------------------------
Suitable for: Mazda MPS (Mazdaspeed) 3, 6 and CX7
IMPORTANT NOTES:
Please refer t
Please thoroughly read and understand these instructions before commencing this installation.
The thread on the cap for the vacuum source is AN#3. The standard swivel nipple can be changed to a AN#3 fitting if desired.
RECOMMENDATIONS
•
Turbosmart recommends that your Blow off valve (BOV) is fitted and adjusted by an appropriately qualified technician
Turbosmart recommends that a boost gauge be permanently fitted to the vehicle
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOV
Please check that the following items have been provided in your Mazda Supersonic kit.
Quantity
Description
Use
1
Mazda Supersonic BOV
Model Specific blow off valve
1
Port blanking plug
To blank off a port to convert the BOV to full atmospheric or plumb back
1
29mm PB Hose blank
To black off OEM plumb back hose
1
Gasket
To seal the BOV to the intercooler pipe
Installation on a Mazda (Diagrams are from a Mazda 3 MPS)
1)
Remove the engine cover by removing the two securing screws/plugs.
2)
Locate the intake standard BOV. Remove the vacuum/pressure source.
3)
Remove the bolts securing the standard BOV and then remove the plumb back hose by removing the spring clamp.
Product Name:
Mazda Supersonic
Product Description:
Model-Specific Supersonic BOV
Product Number:
TS-0205-1309/TS-0205-1310