Turbosmart WASTEGATES – EXTERNAL - Hyper-Gate45 (with locking ring) User Manual
Page 4
www.TURBOSMARTONLINE.com
4
IMPORTANT NOTES ON SETTING THE WASTEGATE SPRING PRESSURE
A stiffer spring should only be used when necessary. The Hyper-Gate45 allows for different combinations of spring pressures. All
springs that are adaptable with the Hyper-Gate45 are shown in the table below. The tuner can use combinations of up to 3 springs to
achieve the following base boost pressures. To aid in the identification of these springs they are supplied colour coded. If this colour
coding is not clear please use the dimensions in the following table to identity the wastegate spring. Please see the following detailed
instructions on setting your Hyper-Gate45’s spring pressure. The springs chosen should be rated to the lowest boost level desired.
Pressure rating
3 PSI Inner
5 PSI Inner
7 PSI Middle
11 PSI Middle
10 PSI Outer
7 PSI Outer
Part number
TS-0505-2001
TS-0505-2002
TS-0505-2003
TS-0505-2004
TS-0505-2005
TS-0505-2006
Colour
BRN/BLK
BRN/GRY
BRN/PUR
BRN/RED
BRN/BLU
BRN/PNK
Dimensions
29mm OD,
32mm Length
29mm OD,
36mm Length
36.5 OD, 43mm
Length
36.5 OD,
52mm Length
44mm OD, 68mm
Length
44mm OD,
57mm Length
Desired Boost
Pressure
PSI
BAR
KPa
3
0.207
20.68
▲
5
0.345
34.47
▲
7
0.483
48.26
▲
10
0.69
68.95
▲
11
0.76
75.84
▲
12
0.827
82.74
▲
▲
13
0.89
89.6
▲
▲
14
0.965
96.53
▲
▲
15
1.03
103.4
▲
▲
16
1.1
110
▲
▲
17
1.172
117.2
▲
▲
19
1.31
131
▲
▲
▲
20
1.38
138
▲
▲
▲
21
1.45
145
▲
▲
22
1.517
151.7
▲
▲
▲
23
1.59
159
▲
▲
▲
24
1.655
165.5
▲
▲
▲
26
1.793
179.3
▲
▲
▲
Changing the springs
WARNING! Fitting a heavier wastegate spring may cause a higher than expected increase in boost pressure.
Turbosmart recommends adjusting your boost controller back to its minimum setting and measuring the new minimum boost pressure
achieved by the new spring, before increasing your boost pressure again.