Turbosmart BOV ADAPTERS - Smart - Manual (Page 2)

SMARTCAR FORTWO BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-SMART
Step 5. Install one of the Silicon joiners supplied onto
the intercooler housing and secure it with the 50mm
hose clamp supplied. Then fit the left hand side of the
Smartcar adaptor onto the intercooler housing Silicon
joiner.
Step 6. Install the other Silicon joiner supplied onto the
throttle body and secure it with a 50mm hose clamp.
Then fit the right hand side of the Smartcar adaptor
onto the throttle body Silicon joiner.
Step 7. Tighten the two 50mm hose clamps supplied
on the throttle body side with a 7mm socket or
screwdriver. Step 8. Tighten the two remaining 50mm hose clamps
supplied on the intercooler side with a 7mm socket or
screwdriver.
Step 9. Remove the factory boost/vacuum line to expose the fuel-pressure regulator fitting.
Throttle Body
Fits onto intercooler
housing
Fits onto
throttle body
Side