Grain Systems PNEG-1755 - Manual (Page 16)

4. PLC WatchDog Operation
16 PNEG-1755 PLC WatchDog
Editing Variables
All of the previous listed variables can be changed by the following instructions; we will use Grain Temp
as an example.
Navigate to the GSI PLC WatchDog web page. - (See Figure 4A on Page 12.)
Select “View Data”. - (See Figure 4B on Page 12.)
Select “PLC WatchDog”. - (See Figure 4D on Page 14.)
Select “Edit” next to the Grain Temp variable.
In the box labeled “New Value”, enter your new setpoint.
Figure 4F
Click “OK”. (See Figure 4F.)
You will be re-directed back to the “PLC WatchDog” on Page 14 .
Verify your new Grain Temp setpoint is listed as the “Value”. (See Figure 4G on Page 17.)