Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Power Pack with EconoMind and Banks iQ w_optional DynaFact Gauges 5.9L (Class-A w_Allison 2000-3000 Trans '03-07), 6.7L (Class-A, All Trans) '07-09 - Manual (Page 3)

96828 v.4.0
3
Dear Customer,
if you have any questions
concerning the installation of
your Banks EconoMind Diesel
Tuner, please call our Technical
Service Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). if you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at (888) 839-
5600.
Thank you.
1.
For ease of installation of your Banks
EconoMind Diesel Tuner, familiarize
yourself with the procedure by reading
the entire manual before starting work.
2.
The exploded illustrations provide
only general guidance. Refer to each
section diagram in this manual for proper
instructions.
3.
Throughout this manual, the left
side of the vehicle refers to the driver’s
side, and the right side refers to the
passenger’s side of the vehicle.
4.
Throughout this manual, pushers
refers to the engine in the rear, and
pullers refers to the engine in the front of
the vehicle.
5.
Disconnect the ground cable from the
battery before beginning work. If there
are two batteries, disconnect both.
6.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more is
recommended where possible.
7.
During installation, keep the work
area clean. If foreign debris is transferred
to any Banks system component, clean it
thoroughly before installing.
8.
The Banks iQ displays a green
indicator light when the battery is fully
charged. If an orange light is displayed,
the Banks iQ can be charged with the
supplied ac-outlet wall charger. Locate
the supplied ac outlet wall charger, also
located in your kit and plug the charging
cord into Banks iQ. Please refer to the
Banks iQ DashBoard Pc, Owner’s Manual
for additional instruction.
Tools Required:
• 1⁄4” or 3⁄8” drive ratchets with inch
and metric sockets
• Inch and metric combination
wrenches
• Pliers
• Wire cutters
• Wire strippers
• Drill motor
• 1⁄8” Unibit, 3⁄8” Unibit, 1⁄8”, 3⁄16”, 7⁄16”
drill bits
• Tap handle
• 1⁄4“ NPT tap
• Foot-pound torque wrenches
• Penetrating oil or light
lubricant spray
• Heat gun
This product is only for
motorhomes with a 5.9/6.7L
Cummins ISB engines with
Allison 5-speed 2000MH series or
Allison 6-speed 3000MH series
transmissions.
Make sure your system part
number is compatible with your
vehicles transmission. Refer
to title page for part number/
Transmission compatibility.
There is a tag affixed to the
transmission, on the driver’s
side. This will help you to
determine if you have the correct
transmission.
General Installation Practices