Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Power Pack with EconoMind and Banks iQ w_optional DynaFact Gauges 5.9L (Class-A w_Allison 2000-3000 Trans '03-07), 6.7L (Class-A, All Trans) '07-09 User Manual
Page 27
96828 v.4.0
27
6.
Locate the RJ12 cable. See Figure
21. connect the RJ12 cab Harness
connector to the cab Harness
connector that was past through the
firewall.
7.
Plug the RJ12 connector (phone
like connector at one end of the PDa
cable) into the receptacle on the
Banks iQ Bridge Module. See Figure
22.
8.
Route the Banks iQ USB interface
cable from the Banks iQ Bridge Module
under the dash to Banks iQ on top of
the dash. Pull enough cable to reach
the Banks iQ and connect it to the USB
receptacle on the left side of Banks iQ.
NOTE: You may need to loosen or
remove dash panel or covers to install
the interface cable between dash crevice
or behind dash panels.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS EXPECTED TO TAKE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.
9.
Secure Banks iQ Bridge Module under
the dash to any dash frame support
using the supplied cable ties. Use the
cable tie support loops on the side of the
Bridge Module to securely fasten it under
the dash.
10.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
11.
Double check everything to make
sure it is securely fastened and it
is not near any hot or moving parts
before starting engine.
12.
Set up the Banks iQ according to
it’s instructions.
13.
Proceed to Section 10.
WARNING: Below 32
o
F (0
o
C) or
above 140
o
F (60
o
C) The Banks iQ
may be susceptible to damage as a
result of extended direct exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the Banks iQ be removed
from its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period of
time. Gale Banks Engineering is not
responsible for damage to Banks iQ
resulting from exposure conditions
.
-END SEcTION 9-