Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Power Pack with EconoMind and Banks iQ w_optional DynaFact Gauges 5.9L (Class-A w_Allison 2000-3000 Trans '03-07), 6.7L (Class-A, All Trans) '07-09 User Manual
Page 21
96828 v.4.0
21
1.
Locate the Diagnostic Port Harness
in your kit. Locate the round diagnostic
port in your coach. The diagnostic port
is located either:
a) Pushers- Inside the engine
compartment or to the rear of the
engine, accessible from the outside.
b) Pullers- Inside the coach, under the
dash or in the engine compartment,
accessible from the outside.
2.
Remove the protective cap
from the diagnostic port. connect
the Diagnostic Port Harness to the
vehicle’s diagnostic port. The Harness’
connector is keyed, so it can only
go on one way. The Harness’ locking
ring may have to be rotated to allow
the connector to seat all the way into
position. Turn the Harness’ connector
locking ring clockwise (to the right)
until you feel it lock. There may
be some resistance when rotating
the locking ring into the locked
position. Make certain the connector
is locked and secured. Install the
Banks’ Protective cover to the stock
protective cap and twist them until
they lock. This will help keep dirt and
debris out of the caps.
NOTE: Depending on the diagnostic
port’s location, there may or may not
be a protective cap.
-END SEcTION 5-
Section 5
Installation of Diagnostic Harness
If installing gauges, skip to Section 7.
If installing Banks iQ, skip to Section 8.
DynaFact gauges are a useful tool to
monitor vehicle performance. There
is a turbo boost gauge and an EGT
gauge that will measure exhaust
temperatures.
1.
Run the Diagnostic Port Harness
to the Tuner Harness. Use the
Jumper Harness to connect the
EconoMind and the Diagnostic Port
Harnesses together. You should feel
the connectors lock together. Secure
the Harnesses away from hot and/or
moving engine components with cable
ties.
2.
Reconnect the battery ground
cable(s).
3.
Double check everything to make
sure it is securely fastened and it
is not near any hot or moving parts
before starting engine.
4.
Go to Section 10 for transmission
learning procedures.
-END SEcTION 6-
Section 6
Installation of EconoMind Tuner without Banks iQ or DynaFact
Gauges