Rough Country 75141-15 - Manual (Page 6)

PowerBoard ® – Installation Instructions
Rev. L 0713 75141 pg. 6
Once you have checked that the Steps function
properly, reinstall the Step Plates.
Reinstall Step Plates
Due to variations in vehicle build, the PowerBoards ®
may contact the vehicle body when in the up position.
If you would like to stop the board’s travel earlier, install
the supplied PSA Bumpers to the inner links or stick the
bumper to the body at the location of contact.
To stop the board travel earlier, look for the area on the
inner link where the Stop Bumper on the outer link would
make contact if the board did not stop early (see gap in
illustration).
Open the door to lower the board. Stand on the board to
keep it in the down position and shut the door. Remove
the fuse. Peel the backing off of the PSA Bumper and
stick it to the surface on the inner link where the Stop
Bumper will contact it. Do this on both idler and motor
links. Reinstall the fuse and check to make sure the Stop
Bumper hits the PSA Bumper when the doors are shut.
Install PSA Bumper – Optional
PSA
Bumper
Stop
Bumper
Stop
Bumper
Gap
Issue:
• Possible cause
Boards do not operate:
• Connected to incorrect vehicle wire
• Wire connections not secure
• Fuse burned
• Factory door-ajar circuit inoperable
Board creaks or squeaks during operation:
• Gear shaft wedge bolt is loose
• Loosen mounting bracket and board
attachment screws. Adjust linkages so they
are parallel to each other and the noise is
gone. Tighten all fasteners.
PowerBoard ® Troubleshooting
Intermittent operation:
• Wire connections not secure
• Bad ground
• Bad battery connection
Boards operate randomly:
• Wire connections not secure
• Connected to incorrect vehicle wire
Board stays down all the time and can be
moved by hand:
• Gear shaft wedge screw is missing or loose
Board shakes and or shutters during operation:
• Bad ground
• Wire connections not secure
• Bad battery connection
One or more doors operate the board and other
do not:
• Wire connections not secure
Board Hits Body:
• Install supplied PSA bumper per the
installation instructions