Rough Country 75141-15 - Manual (Page 4)

PowerBoard ® – Installation Instructions
Rev. L 0713 75141 pg. 4
Route the long leg of the Wiring Harness across the
fi rewall through the plastic cowling and down to the
driver’s side wheel well. Continue along the frame.
Use the 7" Cable Ties to secure the harness along
the way.
Route Wiring Harness
Remove the
passenger side
front kick plate
and door sill. Roll
back the carpet to
access hole in fl oor.
Remove Kick Plate and Door
Sill – Passenger Side
Remove the tape covering the 3/4" hole in the fl oor
above the Idler Linkage. Install the Grommet in the
hole. Thread all four (4) trigger wires from the Wiring
Harness through the Grommet into the vehicle. Seal
the hole with silicone sealant.
Install Grommet –
Passenger Side
Connect Wires
Locate the connector under the kick plate and
unplug it.
Use the Posi-Taps™ to splice the trigger wires
into the like colored wires in the wire bundle.
SuperCab and Regular Cab: Connect the two
(2) extra trigger wires to the same wires listed,
Green connects to Green / Violet and Yellow
connects to White.
Reinstall the connector.
Make sure that each Posi-Tap™ makes positive
contact with the copper wire inside the insulation.
Posi-Tap™ Instructions
Insert Tighten
Strip 3/8" Insert and
Tighten
SUPERCREW SUPERCAB REGULAR CAB
Green / Violet Green / Violet Green / Voilet
Green White White
Yellow
White
Long
Leg
Kick
Plate
Door
Sill
Grommet
Wire
Harness
Unplug
Connector
Posi-Taps™
Occasionally the actual wire color may be different than
stated here. You will need to install the motor and test
each wire until you fi nd the wire that functions correctly.