Rough Country 75141-15 - Manual (Page 3)

PowerBoard ® – Installation Instructions
Rev. L 0713 75141 pg. 3
Ground
Counting from the front, locate the fi rst (1st) and last set of mounting holes on the
inner sill. Use a Small Hex Bolt and a Small Washer to install a Mounting Clip on
each side of each hole. Do not tighten the bolts at this time.
View from under vehicle
Front
Rear
Driver’s Side
Mounting
Clips
Small
Washers Hex Bolts
Idler
Assembly
Motor
Assembly
Install Mounting Clips - Driver’s Side
Mount the Motor Linkage to the rear and
the Idler Linkage to the front on both
sides of the vehicle. Slip the notches in
the Arms under the bolts and washers
installed in Step One.
Finger tighten fasteners at this time.
Secure the bottom of the Arms with two
Small Hex Bolts and Small Washers.
Do not tighten the bolts yet.
The Motor Linkage mounts toward
the rear of the truck, except for the
passenger side on SuperCab vehicles.
Motor
Linkage
Driver’s Side Rear Arm
Small Hex
Bolts
Small
Washers
Rear
Front
Tighten Bolts to
16 ft./lbs. (22Nm)
Install Linkages
Remove the fuse from the
Wiring Harness.
Remove the fuse from the Wiring Harness. Failure
to do so could result
in severe electrical
shock which could
harm the installer
and/or damage the
vehicle.
Remove Fuse from
Wiring Harness Connect the Wiring Harness to the Controller.
Make sure that the locking tabs are fully engaged.
Use the 11" Cable Ties to
mount the Controller to
the factory conduit.
Install Controller and
Wiring Harness
11" Cable
Ties
Controller
Wire
Harness
Connect the red
power lead to the
positive battery
terminal and the
black lead to the
negative terminal.
Route the shorter
leg of the harness to
the wheel well on the
passenger’s side.
Use the 7" Cable
Ties to secure the
harness.
Connect Wiring Harness
to Battery
If the sheet metal holes are
misaligned, you may need to
fi le off the edge of the sheet metal.