Rough Country 692.20 - Manual

Rough Country recommends a certified technician install this system. In addition to these instructions, profes-
sional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. At-
tempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating
safety of the vehicle.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you
have all needed parts and know where they go.
Thank you for choosing Rough Country Off Road Gear for your suspension needs.
PRODUCT USE INFORMATION.
As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover
resistance by increasing tire track width. In other words, go "wide" as you go "tall". Many sportsmen remove their
mud tires after hunting season and install ones more appropriate for street driving; always use as wide a tire and
wheel combination as possible to enhance vehicle stability.
Seat belts and shoulder harnesses should be worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capability are decreased when significantly larger/heavier tires and wheels are used.
Take this into consideration while driving.
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height
of the Rough Country product purchased. Mixing component brands is not recommended. Rough Country makes
no claims regarding lifting devices and excludes any and all implied claims. We will not be responsible for any
product that is altered
The required installation time for this system is approximately 2 hours (see recommended tool list on last page).
You don’t have to lift the hood, spend time removing batteries, on-board electrical components, or the air intake to
get to the upper strut mounts and no strut compressors required.
This suspension system was developed to run up to 265/70/R16 or 245/75/R16 tire on a 7” or 8” wide wheel. Be-
fore installing other combinations, please consult your local tire and wheel specialist.
This suspension lift is designed for use on a 2003 – 2005 2wd or 4wd Liberty only. Because of modifications
made to the Liberty after the first year of production this kit will not work on the 2002 Liberty without modification.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of
our products.
NOTICE TO VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the
inside of the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is op-
erating the vehicle of its unique handling characteristics.
INSTALLING DEALER it is your responsibility to install the warning decal and forward these installation instruc-
tions on to the vehicle owner for review. These instructions should be kept in the vehicle for its service life.
92169200
03 to 07 Jeep Liberty 3” Kit